例句與造句

1. It is well established that facet damage is caused by the optical flux density at the laser facet and that it is not a function of the operating current .
   業已明確肯定，端面損傷是由激光器端面的光流密度引起的，并且不是工作電流的函數。
2. Operating voltage : 3 5 vdc operating current : 25 150 ma
   Add :西安高新區科技5路22號
3. Continuous operating current
   連續工作電流
4. Ratio of peak lamp current to rms or average lamp operating current
   燈電流峰值與rms （均方根值）或平均工作電流的比值。
5. Only licensed banks may operate current or savings accounts . they may also accept deposits of any size and any maturity from the public
   只有持牌銀行才可經營往來戶口或儲蓄戶口業務，并可接受公眾任何數額及期限的存款。
6. It's difficult to find operating current in a sentence. 用operating current造句挺難的
7. Only licensed banks may conduct full banking services , including operating current and savings accounts and accepting deposits of any size and maturity
   只有持牌銀行可從事全面的銀行業務，包括經營往來與儲蓄帳戶業務，以及接受任何數額與期限的存款。
8. Working voltage : 5 24v operating current : 10ma 24v static 0 . 6ma output signal connection : examines outputs 1 second low level to a vibration sensitivity : continuously may move outlook size : 50 30 20mm
   工作電流： 10ma24v靜態0 . 6ma輸出信號接口：檢測到一次振動輸出1秒低電平靈敏度：連續可調
9. In hong kong , only licensed banks may operate current and savings accounts , and accept deposits of any size and maturity from the public and pay or collect cheques drawn by or paid in by customers
   在本港只有持牌銀行才可經營往來及儲蓄戶口業務，并接受公眾任何數額與期限的存款，以及支付或接受客戶簽發或存入的支票。
10. The simulation results show that to start the oscillation , the length of the resonance cavity must be well matched with the radial span of the cavity ; mismatch of them will greatly affect the microwave development ; the output power of the microwave in rtto is affected by the microwave mode obviously . under the same conditions , the output power for temooi mode is the highest , and its start and saturation time of oscillation are the shortest . the results also show that the output power will decrease with the increase of the size of the extract window ; the operating state of rtto has great close relationship with the operating current , and there exists an optimum current value
    結果表明，束電壓一定時，諧振腔腔長和徑向間距必須良好匹配微波才能起振，匹配不佳會極大地影響微波產生；微波模式對微波產生功率影響很大，同等條件下， tem _ ( 001 )模式的微波功率最高，起振時間和飽和時間最短；微波輸出功率隨提取口的增大而減??； rtto工作狀態與工作電流的大小關系密切，存在一個最佳工作電流值。
11. In a room containing a bath or shower , the provision of socket outlets should comply with iec 60364 - 7 - 701 ( to be installed at location 0 . 6 m away from shower basin or bath tub ) and the socket outlets should be protected by a residual current protective device ( rcd ) with a residual operating current not exceeding 30ma
    設有浴缸或花灑的浴室內，插座應符合國際標準iec60364 - 7 - 701的規定（包括安裝的位置距離浴盆或浴缸0 . 6米以外） ，并由馀差啟動電流不超過30毫安的電流式漏電斷路器加以保護。
12. The third one , we calculated the local facet temperature theoretically and experimentally when ld are operated , the former , we used the henry ' s model , however , the latter , we chose the photoluminescence and raman spectra , finally , we found that accuracy of pl is better than that of raman spectra , however , theoretical results is higher than trial results , but theoretical results accorded with pl when operating current increase . the fourth , electric derivative testing techinque at the constant current ( 500ma ) and temperarure ( 40c ) . we study the reliability of ld , and analyzed the reasons , we measured more than the ingaasp high power semiconductor lasers with electric derivative technique , and analyzed the relation between the electric derivative parameters , m , b , h and reliability of devices
    分別從理論上和實驗上計算分析了激光器在工作時腔面的溫度分布，理論上采用的是henry模型，實驗上通過光致發光和拉曼光譜法測試了激光器在工作時的腔面溫度分布；結果表明光致發光法測量的較為準確，拉曼光譜法測量的值偏大，由于我們對理論模型做了一定的近似，理論結果偏大，但理論值在大注入時和光致發光法符合的較好，由此可見光致發光法對研究腔面的溫度有更大的優越性。
13. The traditional bandgap reference circuit was improved in the design , which includes the applying of self - bias structure and cascode structure , output of the opamp was used as self - bias voltage , saving bias circuit , and then it was helpful to get low power consumption . through using poly resistance of high value with low temperature coefficient , we reduced the influnce to circuit , if power supply did not change , we must decrease operating current to decrease power consumption , and increasing value of resistor could decrease the operating current efficiently . poly resistance of high value had large value of squared resistor , so we could save layout area
    對傳統帶隙基準電路進行了改進設計,采用自偏置結構和鏡像電流鏡結構,利用運放的輸出電壓作為運放的偏置電壓,節省了偏置電路,降低了功耗;使用低溫度系數的多晶硅高值電阻,降低了電阻溫漂對電路的影響;在電源電壓不變的情況下,為了減小功耗就必須減小工作電流,而增大電阻的阻值能有效地減小工作電流,多晶硅高值電阻的方塊電阻很大,可以節省版圖面積。